WattRunTime.com
Language

12V portable cooler Runtime Estimate

12V coolers can be efficient on DC, but duty cycle depends on ambient temperature and insulation.

Use this load in the runtime calculator

Planning wattage range

35-75 W. Use this as a planning estimate, not a guaranteed runtime claim.

Planning default

50 W × 60% = 30 W (Average load).

Confidence

estimated. Use this as a planning estimate, not a guaranteed runtime claim.

Static example · 1,024 Wh

Assumptions: 50 W, 60% duty cycle, 90% AC efficiency, 10% reserve, new battery, no temperature loss. Usable capacity: 829 Wh. Estimated runtime: 1d 3h. Fixed station overhead unknown; not included. Runtime does not prove a station can start a compressor or motor.

Evidence behind these load values

Published device values and editorial calculator assumptions have different evidence. An editorial range is a starting input, not a measured category range; replace it with your device reading. Context links explain units or compatibility and do not prove the numbers. The check date records the evidence classification, not a new hardware test.

Evidence type
Editorial planning default
Source type
Official
Confidence
Estimated
Conditions
12V coolers can be efficient on DC, but duty cycle depends on ambient temperature and insulation.
Swipe table sideways
Evidence behind these load values
ValueEvidence typeConditionsSource and datesConfidence
Planning wattage range35-75 WEditorial planning default
  • Operating state: Unknown
  • Output path: Unknown
  • Measurement interval: Unknown
No separately attributed sourceSource date: UnknownChecked:
estimated
Planning default50 WEditorial planning default
  • Operating state: Unknown
  • Output path: Unknown
  • Measurement interval: Unknown
No separately attributed sourceSource date: UnknownChecked:
estimated
Duty cycle60%Editorial planning default
  • Operating state: Unknown
  • Output path: Unknown
  • Measurement interval: Unknown
No separately attributed sourceSource date: UnknownChecked:
estimated

Device measurement guide

Use the measured average

Enter a steady watt reading or a full-cycle average in the runtime calculator. Use 100% duty cycle for an average that already includes on and off periods.

Device wattage (W)
Read watts after a steady load settles; record energy over time for a cycling load.
Duty cycle (%)
Average watts calculated from Wh divided by hours already include off-cycle time, so do not apply duty cycle again.
How to Measure Device Watts for Runtime Planning
Use this load in the runtime calculator

Verify your watts

  • Check the device label for running watts or input amps and volts.
  • Use a plug-in watt meter for AC loads when the result matters.
  • For cycling loads, measure long enough to capture on/off behavior.
Open wattage library

Check output path

  • AC inverter loads usually lose more energy than direct DC loads.
  • Keep reserve for cold weather, battery age, and load changes.
  • Do not treat label capacity as fully usable watt-hours.
Read the method

Planning notes

  • Assumptions: 50 W, 60% duty cycle, 90% AC efficiency, 10% reserve, new battery, no temperature loss.
  • 12V coolers can be efficient on DC, but duty cycle depends on ambient temperature and insulation.
  • Keep reserve for cold weather, battery age, and load changes.

Assumptions to check

  • These are calculated planning estimates, not measured runtimes. Actual results vary with load, battery condition, temperature, and output path.

Sources

Use this load in the runtime calculatorCheck source wattage rangesFind a practical power station sizeCompare runtime by battery capacity

Related Scenarios

Compare nearby loads before assuming one wattage profile covers your setup.

Mini fridge

50-100 W, default 75 W, confidence: Estimated.